You may also use the square button on the right of the bomb button to mark a location where no bomb is present according to your guess. If you would like to place the label elsewhere, simply click the label again to remove it. To start guessing the locations of the bombs, you can click the bomb button on the lower left of the timer, and click a position on the grid to label a possible location of the bombs. A timer is located on the right of the grid, indicating the remaining time. Finally, a probe may also come out from where it enters if it comes between two bombs or hits two corners of a bomb, and this is known as a "Reflection", which is marked by an arrow. A probe that is deflected and comes out on the other side is known as a "Detour", and it will be marked by numbers on the squares to locate its entrance and exit. When a probe comes next to a bomb, it will be deflected 90 degrees to the right if it is on the right-hand side of the bomb, or it will be deflected 90 degrees to the left if it is on the left-hand side of the bomb. This is known as a "Hit" and is marked by an explosive icon. ![]() Always travels in a straight line, a probe will stop when it comes into direct contact with a bomb. ![]() After sending a probe, the result will be shown on the squares. Before locating the bombs, you can send probes into the grid by clicking the squares outside the grid one at a time and observe the paths of the probes. Being a member of an elite bomb disposal team, you are given a task of locating all 5 bombs hidden in a 8x8 grid within the time limit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |